Friday, 27 November 2015

Drip drip...

Improving the tray set-up:

A washing machine drip tray offered an affordable solution - problem was the raised centre section and what to do with it..? If I left the press squash it, it would most likely crack... so:

 ...armed with some cash I paid my local Direct Plastics a call. I got some sheet for an infill...

 carefully cut base infill

...same again on top side

Hole carefully drilled

to take Vit C tube

being carefull it's a tight snug fit

and finished job

and in use with newly aquired plastic food tray bases (though I could only obtain 5 so still need plywood racks...)

So, a big improvement over the plywood tray and necessary with the bigger food tray bases as racks

No comments: